Quote:
Originally Posted by Arctic
Hi Would question ECP with regards to this mount having KKB101914 on in their words ( Please note there is a part number KKB101914 stamped into the rubber which the petrol part number
there is only 1 set of tooling used for petrol & diesel mounts.)
ECP also say the same for the lower engine mount, Stating it now as a letter M on it instead of the letter T. saying one mould etc ? what happened did they throw away all the diesel mount moulds
https://www.ebay.co.uk/itm/GENUINE-R....c100008.m2219
Its open to abuse in my opinion, extra cost but same mounts as petrol which are cheaper by nature.
Quote:
Devils in the detail so the saying goes, so whenever buying anything read the listing then read it again.
|
|
Just to bring this into focus the mounts i have highlighted above will not fit the diesel as they are 15mm to high once in the holding cage on the front arm.
I found this out recently when i went to fit one to my tourer, unless someone knows different.
Original to the left.
1
2
The mount fits into the alloy cage on the diesel.
3
4
The height difference would throw the engine higher on that side by 15mm in my opinion as anyone fitted one of these to a diesel without any problem ?
Rimmers mount but then state below.
https://rimmerbros.com/Item--i-KKB101923
This part has been supersededUse KKB101914
Which is a petrol mount for 2.0 and 2.5 which is why its higher as it does not sit in a cage, it sits on the front chassis arm
Petrol mount fitting.
5
As opposed to the diesel mount.
6