Quote:
Originally Posted by Savestones
Hi Simon, with the idle air control stepper motor, do you mean this part?:
|
Yes (you do have to buy the housing as well, the motor isn't available separately as I incorrectly said earlier. Sorry about that!
).
Quote:
Originally Posted by Savestones
If so, then I'll probably end up replacing it and will fit the Rimmers repair kit Trikey suggested ...
|
I had exactly the same symptoms as you have Nathan and I only renewed the motor which cured the fault. So buy the repair kit if you want to but I think you'll be wasting your money. Why not try the motor first and see what happens?
Quote:
Originally Posted by Savestones
|
The information I gave you was from MG Rover's technical manual RAVE and it actually applies to the Throttle Position Sensor (1.8 engines only) not the stepper motor! I have informed Rimmer Bros.
Quote:
Originally Posted by Savestones
So air flowing from the valve assembly -> hose, meaning a loose hose will be blown out of the valve assembly instead of being sucked onto it.
Anyway I'll get around to replacing the adhesive gum asap.
|
That fitting to which the tube is connected should positively connect to the IACV housing with a click. Some up and down movement is normal but it should not be possible to lift out the fitting without depressing the locking collar.
Simon