Quote:
Quote:
Originally Posted by COLVERT
Peter. There is a fair chance the existing brushes will look like those in the picture below.--The only way to find out is to remove the fan.--Lots of info on the forum how to do it.---( In the--How-To's )
|
|
Hi Jon.
That is a very old photo of mine back in 2011, and it was a very bad fan motor had burned out, so you can see from the board.
Most fan motor if caught early the brushes for the low and medium will need changing out, but always best to swap all of them.
As you can se this one was bad also.
1
This one was serviceable
2
Peter should check to see if he can see a silver resistor or not, if yes then he needs a gold resistor.
3
It could sometimes be the PCB
4
If not maybe some new brushes or contact me