Thread: Wishbone Help
View Single Post
Old 8th June 2021, 11:21   #1
BillyMG
Gets stuck in
 
MG ZT 2.5 V6 Auto Tourer (Elizabeth) / MG ZT CDTI (Farage)

Join Date: Jan 2017
Location: St Helens
Posts: 688
Thanks: 339
Thanked 109 Times in 89 Posts
Default Wishbone Help

I'm trying to replace the driver's side wishbone and have the difficult roll bar bush bolt half way out but have rounded the head on it. Seemed to be coming along quite nicely but a couple of turns rounded it. If I can get the bar steward back in, am I able to take out the wish bone bolts with an offset ring spanner? I'm looking at my options with that roll bar bolt and they seem very limited. I've been at it for 3 hours now - I've got deep sockets, swivel heads, extensions etc but just don't seem to be able to get any decent purchase on it. I've ordered some deep sockets on Prime that are hexagonal and am hoping I can get the bolt tightened up again with one but will I still be able to do the original job?
BillyMG is offline   Reply With Quote