I was a bit concerned that it would be a bit of a pain when I had to do mine.
The most awkward bit is feeding the pipe to the bell housing connector through.
Take a good look at the route it takes across the bulkhead before you withdraw the old one.
You will have to keep going from footwell to under the bonnet to route correctly if you are on your own.
I got mine almost through the realised I had gone the wrong side of one of the pipes across the bulkhead somehow and had to withdraw it and start again.
Avoid that and you should be fine.
Good luck!
Brian
Doh!
What a plonker!
I read one thing in your post and totally mixed it up in my mind.
Last edited by brianw; 15th April 2018 at 09:38..
|