Quote:
Originally Posted by AndyN01
Just a general question.
Exactly which nuts are more likely to need the "extra" oomph of a 3/4" impact socket. Over and above a 6 sided flat drive 1/2" socket plus 3 foot long breaker bar (or even short scaffold pole).
i.e which ones am I likely to find especially difficult
Thanks in advance.
Andy.
|
The nuts on the end of the drive shaft are tight and I decided to get an impact wrench bigger then the one I used to undo them.
It was not the 3/4 that was important but the torque it could muster.
macafee2