Quote:
Quote:
Originally Posted by Kroll
Fantastic instructions so far, thanks Arctic!
|
|
Hi Tom.
From following the above instructions and photos you should be at the stage of removing the fan/cowling from the car, the car in these photo's is a MGZT 190 bit 1.8 will be the same more or less.
1
make sure the A/C pipe connections are out of the way, undo and remove two 8mm bolts either side of the fan cowling.
2
3
Then at the bottom of the fan cowling underneath you will see two clips remove these.
4
With the fan remove you can now remove the condenser.
5
Undo the two 8mm bolts going through the radiator into the rear of the condenser at the top.
6
7
Now you can lift up the condenser from the car.
8
Fit new condenser and re-fit the fan, slam panel, bumper remember use new seal O-rings on the connections to the condenser.
9
good luck give it a go