Quote:
Originally Posted by cbr1100xx
Thanks so far.
My compressor is 100lt , 14.6 cfm and was thinking of one of the smaller bench mounted cabinets which is why I wanted the arm size to see if they would fit.
The sealey one you linked to is either huge or the roof is very low .
I have quite a few bits of both cars and bits off the bike to do so initially it will get some use.
Stan
|
Make your own?
I made my own from plastic storage boxes for small components. two holes in the side, poundland floor tiles on the back and base and a clear piece of perspex cut into the lid, using heavy rubber gauntlets, £20 it cost and it worked! But the compressor was not up to the task, so ultimately had the parts done professionally.
I was even going to use a garden plastic storage container for my subframe lol
The cost/use of buying a cabinet then storing would be an issue for me. However, if it does start to get in the way, it is one of those things that will hold its value quite well, and there is always someone wanting to buying one.