Quote:
Originally Posted by biggles-1
Dear Mike,
Please read my Post # 1 and you will see why :-).
My apologize if my english makes you guys confused, but I take that most of you do not speak Swedish :-).
Regards Nils
|
You are right there Nils - despite working for Tetra Pak for many years and visiting Lund and Malmo many times my Swedish is pitiful - my first visit to Sweden was the port of Ornskoldsvik, and to this day I can't get the pronunciation right.
Quote:
Originally Posted by biggles-1
I had your puller in mind when I wrote the above. However, I do not believe that I can insert the tool into the gap of 0,2mm without risk of moving the flange at the same time, due to the pressure needed.
|
I'm lucky I have an SKF puller kit with fingers that fit inside the bearing making it easy to pull off.
Quote:
Originally Posted by vitesse
The actual pumps are expensive to buy, so your efforts identifying gasket sets/renovating pumps might prove extremely useful
Mike
|
Worth contacting Mickyboy on here for a good value used pump Mike.