The 75 and ZT Owners Club Forums - View Single Post

Mr bountyfull · 6th July 2018, 14:55

Hello folks my number plate lights are not working.

On investigation the the 12v connector within the boot lid has no voltage present. the 0v line connector has good continuity to ground. The Haynes workshop manual schematic shows the 12v feed direct back to connection 17 on the lighting control unit. I want to check that the unit is exporting the 12v and if so the problem is either the crimp connectors or a break in the wire (no interconnector plugs by diagram) I have wiggled the the wiring at flexing point leaving the boot lid and entry into the bot itself, no joy.

So can anyone tell me the location of the Lighting Control Unit?

Regards Steve

6th July 2018, 14:55	#1
Mr bountyfull Gets stuck in MGZTV8 Join Date: Aug 2008 Location: Newbury Posts: 567 Thanks: 173 Thanked 82 Times in 58 Posts	Location of Lighting Control Unit Hello folks my number plate lights are not working. On investigation the the 12v connector within the boot lid has no voltage present. the 0v line connector has good continuity to ground. The Haynes workshop manual schematic shows the 12v feed direct back to connection 17 on the lighting control unit. I want to check that the unit is exporting the 12v and if so the problem is either the crimp connectors or a break in the wire (no interconnector plugs by diagram) I have wiggled the the wiring at flexing point leaving the boot lid and entry into the bot itself, no joy. So can anyone tell me the location of the Lighting Control Unit? Regards Steve