Quote:
Originally Posted by mss
Yes - but I would always put something soft such as a square of wood or an ice hockey puck to prevent the jack causing any localised indentations or damage to the coatings.
|
I was planning on using a 200mm length of wood sleeper - either on the same axis as the sill, or at 90 degrees to it.
I was just wondering whether it would be better with or without the jacking pad in between the sleeper and the car. Without the pad, the sleeper would be touching/lifting either side of the jacking point (as well as the jacking point itself) - is this ok? That's the vital question.
(Perhaps I should start a separate thread on this
).