View Single Post
Old 2nd August 2016, 10:58   #1
Arctic
Give to Learn
 
Arctic's Avatar
 
Freelander 2

Join Date: Aug 2010
Location: West Midlands
Posts: 18,651
Thanks: 1,155
Thanked 6,407 Times in 3,874 Posts
Default Tyre Protectors ( Fitted ) 2015

This is how I/we fitted the tyre protectors (RSC000131) to our cars.
1a

To do this easy task of fitting the protectors you will need either a small screwdriver, or punch, sockets 8mm & 10mm & ratchet, trolley jack, or axle stand, damp cloth or wire brush, but I would imagine your normal jack would do the job, if you do use the normal jack for changing a wheel them put the wheel under the sill behind the jack.

I must of had these tyre protectors for at least a year before fitting them, one of those jobs you seem to say to yourself I will do those this weekend but never get round to it.

You should get two tyre protector plates with two bolts to each plate. Fig 1
1

One of the bolts will have a domed surface so you can not go wrong which bolt fits where Fig 2
2

Ok now we know what we have and need lets get the wheel off, handbrake on rear wheels chocked, loosen the wheel studs 17mm then jack the car up. Fig 3/4
3

4

With all the wheel studs removed you can remove the wheel from the car safely. Fig 5/6
5

6

Now the wheel is off and under the sill or put to one side or you may choose to sit on it why you do the fitting of the protectors, you will see the cup of the strut this maybe covered in dirt, if so wipe it clean with a rag or brush it clean with the brush which ever you have to hand.

Once the cup as been cleaned you will notice the two holes in the cup that the protectors fit into, if not these may have dirt in them also, this is when you would use the small screwdriver or as we used a punch to clear the hole, Fig 7/8
7

8

With the cup cleaned/clear offer the tyre protector up to the cup, fit the 10mm bolt Fig 9
9

Only nip this up hand tight at the moment this will allow you to have movement so you can align the 8mm domed bolt Fig 10
10

Align the domed 8mm bolt then nip this up to, go back to the 10mm and tighten with the socket Fig 11
11

Now tighten the 8mm domed bolt Fig 12
12

The tyre protector should be fitted nice and tight Fig 13
13

Refit the wheel bolts/studs again nipped up fig 14
14

Lower the jack and torque up the studs to 125Nm Fig 15
15

Remove the jack and repeat on the other side job done Fig 16
16

Cheers Arctic

Disclaimer:
You are responsible for any work or modifications carried out on your car and you undertake any such work at your own risk.
The 75 and ZT Owners Club nor the original author of this How-To can be held liable for anything that may happen as a result of you following this How-To.
__________________
Arctic
Givology Learn to Give
Everything is Achievable

ad altiora tendo.

Check out our Nano meet dates
http://www.midlandsnanomeets.co.uk/

http://www.the75andztclub.co.uk/index.php?thepage=howto

" You do the work , we supply the expertise "

Last edited by Arctic; 16th February 2020 at 19:22..
Arctic is offline   Reply With Quote