[mgzrjake]

Originally Posted by Arctic

Hi Jake.
That fan is correct for a diesel car it is a two wire 2 speed fan, you have done correct in changing the silver resistor for the Gold resistor.

It should be plug and play, ie you can plug it in to the car loom inside the passenger wheel arch, lean it up against the car or get someone to hold it upright for you.

Turn your ignition to II making sure before hand that all the A/C is in the off position by pressing the off button, on the control panel, now press the demist button the fan should run continually.

If not then either the relay as gone or the PCB board is at fault, the brushes could have been worn right down but very rare on a 2 speed to have completely worn down, but personally I would change them, what we need to do is see if we an get this running.

Do you still have the old fan which you took off.?

yes still have the fan, will temp on panel need to be high on test