Quote:
Originally Posted by macafee2
if I apply an earth to start the FBH but remove it after a few seconds or sooner that if I did this enough times the PCB locks out.
|
If you do it enough times you will get fed up, that is all. A lockout is not stored in physical memory, lockout is sort of remembered, when power is cut, it forgets.
Quote:
Originally Posted by macafee2
Question 1
If, when the temperature is below zero I start the car and then 5 - 10 seconds later turn it off (just need to move car out the way) and I do this enough times, can the PCB lock out?
|
No, if it did, every FBH would be locked out at some point. I would be dealing with lockouts every week. Also "Ian tapping start command" is not a recognised in the software as a fault
Quote:
Originally Posted by macafee2
Question 2
If the FBH in between each brief start of start up procedure, is allowed to fully start and run, will this cancel any "false" starts?
|
No, only 1 way to clear faults from memory.
For anyone who may misunderstand or take me seriously, here are some smileys,