Quote:
Quote:
Originally Posted by martinwest
Bit of an update I have pulled the other injectors and No 4 is rusty down the body of the injector going to check the engine tomorrow with a bore scope  |
|
HI Martin
Clean the body of the injectors, you could then remove the tip and clean those out with carb cleaner so the spray pattern is the same five fine spurts.
1
2
You could go the whole hog a strip down the injectors and clean then all through, you may need new shims or O-rings you will not know until the strip down.
3
Most of the time you will get away with just cleaning the tips
4
5
6
7
8
Make sure you are super clean doing the work.
And always fit new copper washes before re-fitting the injectors, the post hole also need to be clean even if you have to suck out any debris.
9
10
11
12
13
14