Seats in and working.. I've yet to check that the K-Bus connection has been successful (ran out of daylight yesterday), but all seat movements and the heated seat switches seem to be working as intended. Will check K-Bus next weekend, or whenever I get a chance.
Thanks again to Rick for the How-To.
I used piggyback fuseholders with 30amp fuses at the fusebox (slots 49 & 51) for power to each of the front seats - and wired them up following the instructions herein.
For the heated seat switches, I spliced into the red/white sidelight wire that runs to the dash clock. Then got ignition live to the switches by splicing into green/white wire at the stereo harness.
K-Bus from driver's seat is spliced into K-Bus wire at the stereo harness as well.
Earth points are easily accessible on the inside of the A post in both footwells. And the carpet goes snugly back in place if cables aren't wadded-up in a huge bunch..
Cheers,
Karl
|