Fan not working
Hello T Cut I find your posts very informative...so could I ask you another question regarding this problem. The fan blades came away from the spindle so obviously the fan was not working..after a great effect I have manged to put back on again securing with a screw and some glue...
The motor works in the demisting mode...but I am trying to find out why the fan does not come on..it used but stop which I think is causing the over heating problem
So heres the question......People on here have said it could be the resistor in the fan housing a sliver type...which could mean taking the whole front off again, I really dont want to do this.
Do you think it could be the resistor as the motor works ?? or should I be looking elsewhere
If I do need to replace could i fit between the blades without taking the fan off again.??
Any advise would be gratefully received.
Thanks
Bill
|