Quote:
Originally Posted by john adam
Greetings from way down south, how does one get hold of what sounds like an essential tool for the V6 motor? How much to buy one? I read an earlier post where a member made up his own unit, how difficult is this? Don't think I can make the next gathering, bit too far away unfortunately.
|
G'day John (hope you say that in NZ or is it just in OZ)
Building a vis tester is not too difficult even for someone like me a mechanic/welder
the hardest components to acquire are the plugs from the engine loom for the vis motors if you can get these then it's easy enough. Look through the "How To" section all info is there mate.
I recently purchased an engine loom from a breaker in the UK, it cost me £20 sterling. All the other components were sourced from an electronics supply shop. I suppose you could buy all that you would need online also.
If you are interested in building your own tester and can't get the vis plugs I would quite happily try to find a loom for you here in the UK and mail it to you mate.