View Single Post
Old 20th December 2011, 18:15   #3
ja3142
Avid contributor
 
ja3142's Avatar
 
MG ZT 160 + sport, 1.8T

Join Date: Aug 2010
Location: Ipswich
Posts: 139
Thanks: 0
Thanked 0 Times in 0 Posts
Default

I've had this as well, so I sympathise. Drying out the carpet is the worst part.

If you remove the panel under the steering wheel you can eventually find the pipe leading down from the sunroof up in the top right behind the dash. Stick your head down by the pedals and use a torch to find it.

In my case the pipe from the A pillar had come out of the one leading through the bulkhead under the wheel arch. I rodded through the one through the bulkhead with a wire from a coat hanger. By going under the wheel arch (the liner is quite easy to remove) I cut a piece of the end of the pipe to ensure a wider exit for flow. Then I put silicone round the pipe from the A piller, slid it back into the pipe from the bulkhead and then secured it with a cable tie round the outside. Finally I siliconed round the whole lot. Its not easy to get the nozzle up as the pipes are quite high up behind the dash board.

good luck!
ja3142 is offline   Reply With Quote