Quote:
Originally Posted by Jake
I'd put money (not that I have any) on that being the reason. You'll find that most likely that the nav part of the system wouldn't work as that connector is looking for the abs sensor feed (green/grey) isn't connected. I'm pretty sure there is also a K-Bus wire in that connector as well which communicates with the car (trip computer information shared from the IPK for a start.)
When I was in the UK last week I had made an adapter for Dominics V8 and as a result there were some wire rounds where you have to wire the highline loom directly into the car harness. Depending on the age of loom there will be other wires in there that if not fed will cause the system not to work.
Depending on your urgency on getting this all working 100% I am flying back for the next nano and could set it all up then for you as I did Scouses from scratch in a weekend.
More than happy to answer any questions on the e-mail Craig if I can help. Alternatively you can call me.
Jake
|
Thanks Jake. i should say we have found the kbus wire and when the kbus wire on the sat nav loom is connected to the kbus wire on the car we get the blank screen with the white strip and TMC wrote in the white strip but when the kbus wires are not connected then there is just a blank screen.
We are sure if we could find were the green / brown wire and blue / orange wires goes we could get the unit up and working.
If you could pm me your number Jake that would be great as when the other member who is helping me comes around on wednesday evening we could possibley call you for some advice.
Thanks for all your help Jake and Reebs, and of course thanks to all the other members who have helped
