Quote:
Originally Posted by mikeh
I've just removed (keyhole method) the KV6 thermostat and elbow pipe and unfortunately there is still a bit of the elbow stuck in the block. Is there an easy method/tool to get the remains out.
|
Mike, I would urge you to do this job using the official MG Rover method. It's not easy or quick but you will be able to see what you're doing with far superior access. You'll need this when fitting and setting the straight pipe serrated clips to prevent future 'O' ring seal coolant leakage.
Very good advice from
xsport above noting that you'll only need one inlet manifold gasket as the RH bank manifold can remain in situ.
Simon