Quote:
Quote:
Originally Posted by Kenneth Smith
Hi, I have tried to drill out my ABS Sensor (front, Drivers side) and have managed to get to the shiney bit (presumably the Sensor Tip) and am a bit wary about going further. Need advice as to best method of removing the last bit of Sensor without hopefully not stripping the whole Hub assembly. If Hub has to be stripped then best way to carry this out. Regards Ken
|
|
Hi Kenneth.
What you should have done was drill a 3ml hole and then screw in a bolt or wood screw and prise out the stuck ABS sensor.
If you can see something shiney then that could be the bearing it's self, how far in have you gone and what size drill bit you used.
Once you do get it out, the hole will still need to be cleaned out carefully, using a file always hoovering the debris as you go.
PS Mike you beat me to it
