Quote:
Originally Posted by Steve42
Hi trikey,
On the balance vis I get open circuit. So changed it for a known good one. Fault clears. Drove to work and did a test again and get the same fault.
Reversing sensors are the same will work then stop.then start working again.
Fuel gauge is just as random. It could be reading over half a tank full. Then less than half without even turning the engine on. Then it will read above half a tank.
My snap on ethos diagnostic kit says sensor 1 in the tank is faulty. The obd says all is ok.
Test 6.00 I get a reading of fuel.
Test 6.1 all I get is _ _ _ _
Test 6.2 I get 1.6.2 and a reading of fuel.
Have taken a look in the tank and filler side of the tank was full and the float and arm seemed ok.
Passenger side again float and arm seem ok .but not much fuel left in the tank
Car drives well in fact I'm amazed the difference in the two engines
Thanks
Steve
|
I would be attacking the fuel sensor issue first Steve, chances are the sensors will be a dodgy rear loom, I'd check the plug and wiring from the vis motor if you know the replacement is a good one.