Quote:
Quote:
Originally Posted by Happy Wanderer
Just tried doing mine as suggested & as previously mentioned it is now indeed toast!! Suggestions anyone please 😌?
|
|
Hi Andy.
Now you have seemed to remove the sensor by drifting it out, you just need to clean the hole ready for a new sensor to be fitted.
As above choose a decent sensor either from Rimmers or from DMGRS.
1
2
3
4
bit of copper grease on some wire wool.
5
Wrap it round a file round one if you have one, and clean out the hole of rust.
6
Fit the new sensor.
7
Clean up any rust on the back plate etc before adding the new sensor, in this case a new bearing had to be fitted as well.
8