Quote:
Originally Posted by macafee2
I am at my wits end, how on earth do you make the piston dust shield/rubber stay in place on the lip of the caliper?
I think it is all on and it slips off, start at 6 o'clock, work round to 12 and the 6 pops off or the whole thing seems to slip off.
This was a 5 minute job now taking hours
macafee2
|
On mine (as posted in your other post) it went in easily, but then they were effectively new. Have you checked the flange is clean?
If I recall, the clip ring is encased in the rubber. Perhaps placing for a few minutes in hot water to allow the rubber to soften, and the clip ring to expand slightly.