[macafee2]

Originally Posted by T-Cut

To enable the on-board diagnostics:

a) Put key into ignition and turn it to position 1 (instruments activated).
a2) If you intend driving with diagnostic mode active, start the engine now.
b) Press and hold the trip reset button. This is the button sticking out near the speedometer.
c) Your LCD display will show "test 1.-"
d) Immediately press the reset button every half second until you get to "test 19.-". (19.0 allows access to diagnostic mode)
e) The display will now show alternating "Log 1 -on" / "Log 1 -off"
f) While it shows "Log 1 -off" press the reset button and. .
g) With no delay press within a half second (repeatedly if necessary) to get to the required section.
h) The screen will appear similar to the earlier one, but is a different series. Keep pressing every half second to select one of the following functions (there is no title on screen):


If you're not pressing the button immediately after ''test 1.-'' appears, you'll never get into diagnostic mode. Step f) switches on/off the next stage, so follow the guide. And having done that, you must continue immediately every half second to reach function 7, or it will not work. There's a knack in it which you'll get from practising the routine.


TC

thank you Arctic I'll try again. I already had the engine running when I tried and may not have pushed the trip quickly enough

macafee2