Arctic
That's a help but not quite enough! The unit the wires come from is best shown in the 4th pic. It's at the top left corner of the starter motor and bottom left of the bracket with a hole in it that's between the two stainless pipes feeding the HPFP.
But I can't quite make out on the photo to be certain which lead it is and where it goes. But looking at the right hand side of the engine when looking at the photo I recall that there was a grommet and there's a electrical lead with a grommet going between the last inlet and last stud for the manifold on that right hand side. The rest of it looks right too but I can't quite make out the colours in the photo.
I'll pop the manifold back off tomorrow and take a look it's just that I don't think the lead it long enough but we'll see.
Thanks for taking the trouble to post the photos and I'll report back.
Any comments on my mates priming suggestion?
Cheers
JohnnyBG
|