Quote:
Originally Posted by clf
On mine (as posted in your other post) it went in easily, but then they were effectively new. Have you checked the flange is clean?
If I recall, the clip ring is encased in the rubber. Perhaps placing for a few minutes in hot water to allow the rubber to soften, and the clip ring to expand slightly.
|
checked the flange is clean. Did not want to heat in water as that would mean assembling wet so I heated it with a hot air gun.
My fingers are sore from pushing the seal on.
If you think hot water is the answer I'll give it a go, desperation creeping in. Rubber seems very soft, just wondered if there was a bit too much of it. The lip is not very deep.
macafee2