View Single Post
Old 11th January 2019, 14:54   #4
peelaaa
Posted a thing or two
 
peelaaa's Avatar
 
75 cdti 2004 contemporary

Join Date: Apr 2008
Location: meath
Posts: 1,551
Thanks: 272
Thanked 80 Times in 58 Posts
Default

Quote:
Originally Posted by macafee2 View Post
is it just an ipk or the whole thing, rev counter, speedo and gauges?
easy to replace the whole thing.
remove the eyebrow above the existing clocks, 2 screws.
There is then 1 screw centre top at the back holding the clocks in place. Remove this screw
Clocks will then come forward, may need some force. I found if I pulled the dash board forward it was easier to get my hand behind the clocks to push them out.
There are two plugs at the back of the clocks that need to be removed.

before reprogramming "new" clocks just plug them in to make sure the ipk is good but you will need to fit new stalk first.


to replace the stalk. remove the two screws holding the shroud over the steering column. Once apart you should see two screws holding the indicator stalk I place, once these are removed withdraw the indicator stalk from a square box and unplug wiring. refit is just the reverse.

macafee2
Its the whole ipk and I have the stalk with the end button too.I noticed when removing it from the salvage car, my tourer, that the message centre display had a few more lines than when I last checked it.. The car was damp due to lack of use and sitting outside. Probably that.
peelaaa is offline   Reply With Quote