Quote:
Originally Posted by SD1too
Hello everyone,
I've had to abandon the idea of shortening the mounting thread to allow the fitment of a ring spanner. It won't work on the right-hand strut as, due to only 18.5mm clearance below the spring, there would be nothing left for the Nylok nut to attach to. So I've abandoned that idea.
Alan's earlier suggestion seems to be the only solution; a crow's foot spanner and this one from Laser Tools looks promising particularly as it enables the use of a torque wrench.
Alan also came up with the safe solution for the exceptionally slim 5mm holding flats on the ball pin; a 16mm bicycle cone spanner. I'm going for this one which, at 2.5mm thick, will be just right.
Thank you Alan ( clf).
I might be back later in the week if another problem crops up.
Simon
|
Why not an open end spanner? Push the threads through the hole, by hand turn the link, whilst holding the nut with the open ended spanner. Nip tight with the spanner
Sent from my SM-A600FN using Tapatalk