Quote:
Originally Posted by Blink
Which pic are you referring to here? (my pics are numbered).
|
Number 1625. It must be an illusion of scale. It looks broader than mine, but maybe yours hadn't been fully compressed into a joint.
Quote:
Yes, I did use the flat end of the die first - I tightened it as far as it'll go using a 16mm ratchet spanner. It was definitely doing its job because I could see it forcing the pipe out at the other end of the block.
Then I tightened the two 10mm bolts as far as they'd go before reversing the die and screwing it back in again with the 16mm ratchet and making the flare.
|
All correct. Your flares will be correct.
Yes, in the dish around the central pin.
TC