The 75 and ZT Owners Club Forums - View Single Post - Project Drive

p2roverman · 21st March 2023, 16:24

Just noticed on my Cowley car the insulation panel on the front of the plenum chamber is in three pieces. On my 51 reg car it is in one pice; I had the cut it to remove the servo. Was this a Project Drive modification?

Also, I note there is a clamp securing the lower end of the shannon tube, my Y reg car did not have this.

Incidently the trumpet shaped steel inlet pipe for the shannon tube is missing on my Cowley KV6 should anyonr breaking a car be able to supply one with fittings. (I can't find it illustrated on Rimmers' site, not that it's likely they would have it).

21st March 2023, 16:24	#354
p2roverman Gets stuck in Rover 75 Connie Tourer & Connie SE Saloon & Club SE Tourer Join Date: Sep 2014 Location: Leeds Posts: 975 Thanks: 199 Thanked 71 Times in 59 Posts	Sound deadening / insulation Just noticed on my Cowley car the insulation panel on the front of the plenum chamber is in three pieces. On my 51 reg car it is in one pice; I had the cut it to remove the servo. Was this a Project Drive modification? Also, I note there is a clamp securing the lower end of the shannon tube, my Y reg car did not have this. Incidently the trumpet shaped steel inlet pipe for the shannon tube is missing on my Cowley KV6 should anyonr breaking a car be able to supply one with fittings. (I can't find it illustrated on Rimmers' site, not that it's likely they would have it).