Quote:
Originally Posted by rover54
I have sometime in April, intend to make the wooden pattens and then the moulds. I would like to be producing in May if things go to plans. Will post nearer the time with photos. I know that two of my bumpers have fir-trees, will dig them out from the spare room, have a look at them and see what can be done.
Does anybody know if the the standard undertray/side panels and wheel arch liners from a 75 fit the premium bumper or is more GRP fabrication required?
|
I have already done this conversion and the under tray will fit if you also get the oem splitter, otherwise there may be a small gap which could be overcome with tie grips, the wheel arch liner also comes up a fraction short but would be easy to fill the gap with a bit of DIY but I have left mine as it was without any issues
__________________
www.midlandsnanomeets.co.uk
Robs Car Gallery
Coven near Wolverhampton WV9
2000 Cowley Built Rover 75 2.0 V6 Club SE/ Atlantic Blue/ Sandstone/Walnut (daily driver)
2003 Land Rover Freelander 1 TD4 HSE Helsinki Blue/Black Leather (swmbo daily driver)