Quote:
Originally Posted by chris75
... when fitting the small rear belts it is usually necessary to rotate the exhaust camshaft a little . Is this what you are experiencing ?
|
Chris; I think what Frank means is that the notches on the rear sprockets don't quite align with the flywheel/drive plate locking pin in place.
Frank; I and others have found this. Having renewed the front belt, remove the flywheel/drive plate locking pin and rotate the engine very slightly until the rear sprocket notches align. Now you will be able to fit the rear tools.
Quote:
Originally Posted by bl52krz
I notice in the link you put up, it said ‘drain the oil’?
|
That's because the oil cooler pipes need to be disconnected.
Simon