The 75 and ZT Owners Club Forums - View Single Post

Blink · 1st August 2019, 08:40

I'm putting new parts on the underside of my car and I'm looking for advice/ideas on how to protect & rustproof them before they're bolted back on.

New parts include rear subframe, trailing arms, upper & lower arms, brake backplates, discs, hubs, rollbar, etc.

The factory paint on these items isn't the best so I don't know whether to just put more paint on top of the existing paint (after keying it) and then apply wax over the top of that.

Or ...

Strip all the existing paint off (sandblast?) and repaint with primer and top coats, then apply wax on top. This is obviously a very expensive route to take.

Any suggestions?

1st August 2019, 08:40	#1
Blink Posted a thing or two Rover 75 Saloon Join Date: Apr 2019 Location: Under the car Posts: 1,840 Thanks: 210 Thanked 244 Times in 221 Posts	Protecting new parts from rust I'm putting new parts on the underside of my car and I'm looking for advice/ideas on how to protect & rustproof them before they're bolted back on. New parts include rear subframe, trailing arms, upper & lower arms, brake backplates, discs, hubs, rollbar, etc. The factory paint on these items isn't the best so I don't know whether to just put more paint on top of the existing paint (after keying it) and then apply wax over the top of that. Or ... Strip all the existing paint off (sandblast?) and repaint with primer and top coats, then apply wax on top. This is obviously a very expensive route to take. Any suggestions?