Quote:
Originally Posted by SD1too
Thanks to Steve for his method which I followed. I was doing the passenger side and having done the middle finger thing, when I got under the car I noticed that the fuel lines run directly underneath where the end of the sleeve was peeping at me in a tantalising fashion. Having manoeuvred my hand and arm through the only available gap, could I get a purchase on the sleeve with fingers twined like ivy around the fuel lines? Err, no. I'm obviously not as dextrous as Steve! (The driver's side is a doddle with no obstructions.)
So on to plan B; inserting the whole thing upwards from below. I was more successful pushing than pulling and the rubber is thick and unyielding but I did get it located nicely in the lower skin. It was then just a case of teasing the top flange over the upper hole in the plenum and to pour a beer.
Quote:
I think that Steve's recommendation to cut 20mm off the bottom of the tube is a good one because without it the end is pushed closed by the fuel lines bearing upon it. This is probably why it's always the NS which floods and not the OS.
Simon
|
|
Simon.
Just so members know what we are talking about most will but the new comers have all the fun in front of them.
Near side.
1
Off side
2
Reach up a cut 20mm off.
3