View Single Post
Old 26th November 2021, 13:53   #10
rab60bit
Posted a thing or two
 
rab60bit's Avatar
 
Rover 75 Saloon & Tourer

Join Date: Mar 2013
Location: Wilmslow
Posts: 1,509
Thanks: 433
Thanked 301 Times in 212 Posts
Default

Quote:
Originally Posted by mgj11 View Post
I have just replaced my silencer with a new clamshell one from DMGRS. its much larger than the cheap one on the car when I got it. I brought the correct clamp but it seems to rattle around, and makes a knocking noise is there anyway of sorting this out?
Get the pukka rubber jobs (I got mine from Rimmers). My new clamshell (off DMGRS) and new hanger bracket of e-bay (apparently genuine MGR but made of flat galvanised steel rather than the pressed profile now available as OEM) seem to fit and support the exhaust system fine but only the rear black rubbers were replaced because I couldn't source an OEM intermediate section at the time. I've just spent a small fortune on one (and a sleeve clamp) off Rimmers so the intermediate red rubbers will go on when that is fitted.
Amazingly the intermediate section looks to be original because it's integrated with the cat front section - 17 years and 167K later after leaving the factory, not bad.
rab60bit is offline   Reply With Quote