Quote:
Originally Posted by Arctic
Hi Scott
Try drilling a little deeper so you go into the oval by about 6mm then use a wood screw bolts and try to pry it out few photo's below they may help.
Are you at this situation
 1
If so drill that little bit more but be careful so you do not damage the bearing.
Drill an hole with 3mm bit use a screw
 2
Use a 6mm bit and screw if you have to.
 3
Then try prying it out.
 4
Once out either blow out the hole with air line or use an hoover to suck any loose debris out.
This is what the ABS sensor looks like when it is inserted so you can see you can not drill past the point of the inner section wall, as it will damage the ring.
 4
 5
Good luck take your time  |
Many thanks Arctic for some great photography. Its made my job look slightly easier than I envisaged. Especially the point of not drilling too far!
Did you use a standard 12mm drill bit or a reamer ?