Quote:
Originally Posted by Shuknami
I installed in the headlights, in low beams, led bulbs. Although in the announcement of the Italian house, they put free of can bus failure, I ordered some resistors from the same house of 100W 5 Ohm. The bulbs illuminate very well, but as soon as I connect the low beams, the fault appears on the panel. I checked the car bulbs and they are fine. The license plate lights are new. I unplugged the LSD and cleaned it with WD 40 as well as the plug. When connecting again and turning on the parking lights (small), the error does not appear. When connecting the short ones it reappears. I'm fed up with it. Could you locate/clear the fault with TOAF?
|
Check if TOAF will let you turn off hot and cold monitoring of the dipped beam, you won't need the potential fire harzard of a resistor then. I know BMW Scanner can disable the checks.