Quote:
Originally Posted by BLMC
Thank you Dave,
There was a lot useful information.I have been reading trough many older posts about fitting Hiline,but i still dont have idea where exactly harness should be,if i want to go like "factory fit" route.
And i am fitting Tourer harness to Tourer.
Also i would like to know exact location for shark fin aerial hole.
regards
Jussi
|
If you drop down the rear part of the roof lining you can see where the hole has to be drilled.
This picture shows the sharks fin aerial.
You have to remove the trim [marked with arrows] and take the loom over the rear offside wheel arch, under the rear seat and then beneath the offside floor trim, behind the seat belt anchor point and behind the trim holding the bonnet release button, then to behind the center consol.
Dave T