|
||
|
21st October 2019, 21:24 | #11 |
I really should get out more.......
mg 190+ Join Date: Feb 2013
Location: Bedworth
Posts: 2,267
Thanks: 191
Thanked 368 Times in 248 Posts
|
just got the new cap from you and to be honest I hand not noticed how flat the rings had become on the old one.
|
22nd October 2019, 20:14 | #12 | |
This is my second home
Rover75 and Mreg Corsa. Join Date: Nov 2006
Location: Sumweer onat mote o'dust (Sagin)
Posts: 21,751
Thanks: 341
Thanked 3,660 Times in 2,924 Posts
|
Quote:
These data are at normal atmospheric pressure (1 bar/15psi/100kPa) Thus all ethylene glycol based coolants have the same boiling point at the same concentration and pressure. That doesn't change whether it's the latest OAT, IAT, HOAT or any of the earlier inorganic acid varieties (phosphates/silicates/borates/ etc, etc.) The various additives constitute perhaps 5% or so and have negligible impact. Nor do they, inter alia, affect the engine running temperature. The recommended concentration is 50%. If you decide to reduce this to say 30%, then all these numbers reduce as well. So, any coolant containing a 50% EG based antifreeze will boil at around 107°C at normal atmospheric pressure (1 bar/15psi). Of course, our cars operate at an elevated pressure, roughly 1.4bar using a '140' type pressure cap. Thus with the vapour pressure restricted to 1.4bar/140kiloPascals/20psi, the boiling point is raised by about 10°C to 117°C. (This figure is taken from the boiling point curves for aqueous EG solutions at different pressures). Going beyond this point will cause the header tank to vent. Of course, the running temperature isn't controlled by the running pressure. It simply limits it's maximum operating temperature before the coolant starts to boil. TC Last edited by T-Cut; 22nd October 2019 at 20:20.. |
|
Thread Tools | |
Display Modes | |
|
|