|
||
|
3rd May 2009, 18:28 | #1 |
Posted a thing or two
ROVER 75 CONNOISSEUR T SE WITH MISSING SATNAV ROVER P6 2000 SC Join Date: Jan 2007
Location: Doncaster
Posts: 1,484
Thanks: 429
Thanked 77 Times in 44 Posts
|
sounds expensive part 2, rover 75 cdt 02
Right just wanted to let people know all the things we,ve tried so far on the car to try to resolve the situation on our rover 75 cdt 2002.with no joy
1) Injectors have been cleaned profesionally, one was down but working now 2) in-tank fuel pump changed, but 2nd hand one was replacement 3)crank sensor changed 4) cam sensor changed 5)we.ve swapped battery over with Russ one, no joy 6) swapped fuel filter 7)disconnected all sensors we could reach, sprayed them with contact cleaner,then put them back together 8) took ecu out no obvious problems there, no corrosion or anything, 9) the emergency cut off fuel switch under the glove box was fine It cant be the key or immobiliser as the starter motor works, The car ran for about 5 secs at each turn of the key , but then just stops So any more suggestions would be greatly appreciated, thanks, Tim
__________________
Back in Rover land, with 1.8T and Freelander HSE 2.0 td4 |
3rd May 2009, 18:32 | #2 |
Moderator
MG-ZTT Join Date: Mar 2007
Location: Ware, Herts
Posts: 19,798
Thanks: 161
Thanked 1,249 Times in 1,036 Posts
|
As you've pulled the fuel side to bits with no joy, try the air side of things. look for collapsed pipes, beathers or blocakages.
So is it now starting but just not running then ?
__________________
David Impecunity is the mother of ingenuity Useful how to's for common problems Car Of The Month Jan 2014 [SatNav Power Down] [Coolant Level] [SatNav Repair] [Diesel Non Starting] [Paint Codes] [Rear Light Seals] [Reversing Light Switch] [Bleeding Brakes][Sunroof Drain] [Early ZT's][Instrument Pack Diagnostics][ATC Diagnostics] |
3rd May 2009, 18:35 | #3 |
Posted a thing or two
ROVER 75 CONNOISSEUR T SE WITH MISSING SATNAV ROVER P6 2000 SC Join Date: Jan 2007
Location: Doncaster
Posts: 1,484
Thanks: 429
Thanked 77 Times in 44 Posts
|
we get between 2-5 seconds each time we start her up, then its like someone has just hit the fuel cut off switch, no idiot lights coming on, its very frustrating
__________________
Back in Rover land, with 1.8T and Freelander HSE 2.0 td4 |
3rd May 2009, 18:40 | #4 |
Premium Trader
75 CDT Tourer,2.5 Launch Saloon, Omipro MG/Rover (T4) Join Date: Jul 2007
Location: Liversedge, West Yorkshire
Posts: 5,419
Thanks: 1,105
Thanked 1,340 Times in 661 Posts
|
Didn't notice you'd started another thread just posted on other one
So have removed it and re posted here for continuity. Russ
__________________
Replacement Key Service http://https://the75andztclub.co.uk/...d.php?t=244732 Full T4 Testbook diagnostics available. Diesel ECU repair and replacement. Options enabled or disabled as required. Diesel X-Power 135 and "160", Rover 1.8T 150 to 160 MG 160 V6 to 177 upgrades available P.M. for details. Last edited by BigRuss; 3rd May 2009 at 19:07.. Reason: added info |
3rd May 2009, 18:42 | #5 |
Posted a thing or two
ROVER 75 CONNOISSEUR T SE WITH MISSING SATNAV ROVER P6 2000 SC Join Date: Jan 2007
Location: Doncaster
Posts: 1,484
Thanks: 429
Thanked 77 Times in 44 Posts
|
Jim suggested having another thread with everything we,ve done so far on it, it might help,
thanks a lot for today, hope you didnt get into too much bother
__________________
Back in Rover land, with 1.8T and Freelander HSE 2.0 td4 |
3rd May 2009, 18:52 | #6 |
Newbie
rover 75 connoisseur cdt se Join Date: Apr 2009
Location: maidstone
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
|
on older mems equiped rovers that run for a few seconds usualy indicates an immobiliser problem this is most prevailant on turbo conversions in which the immobiliser has not been removed or de-activated within the donor ecu.. as im new to 75's i have no idea wether you can re-code the key to the alarm circuit but you can re sync older rovers where the immob and key have become un sync'd
|
3rd May 2009, 18:59 | #7 |
Premium Trader
75 CDT Tourer,2.5 Launch Saloon, Omipro MG/Rover (T4) Join Date: Jul 2007
Location: Liversedge, West Yorkshire
Posts: 5,419
Thanks: 1,105
Thanked 1,340 Times in 661 Posts
|
According to the official information I have the EWS ECU will cut off the starter relay and the fuel relay if it doesn't recognise the key or the signal to it becomes corrupted. Both of these systems appear to be working as normal.
The engine will run for a maximum of 5 seconds if the following sequence is followed: Key turned to position 2 for a few seconds to prime fuel system, Fuel pumps are "working" Try to start car engine fires but shuts down after a few seconds (I suspect when the fuel pressure drops) continued cranking results in engine sometimes catching for an instant but usually engine just continues to crank. If the sequence is repeated the same result occurs. My conclusion is that the engine when it fires is using the fuel to the point where the pressure drops on the low pressure side of the system which then causes the low pressure sensor to cut the ECU as described in my previous post. (See other thread) There is fuel getting to the H.P. pump but don't know if it's at sufficient pressure to keep the engine running. The pressure should be 3.6 bar and the low pressure switch cuts in at 0.7 bar. I don't unfortunately have a suitable guage. The diesel specialist said he didn't find any faults but don't know if he tested the fuel pressure on the low pressure side. Have discounted the cam and crank sensors, high pressure fuel rail sensor and low pressure fuel sensor in the filter head. All these have been replaced by known working units from my own car. Have checked every connector for cleanliness and security and checked wiring as much as possible including the connections to the ECU. Injectors have been cleaned and "serviced" by diesel specialist. Failing anything else I am tempted to try a new in tank pump and then if it doesn't work I can always keep it as a spare for my own which has now hit 80,000 miles. At least we can then rule out any faults on the low pressure side of the system. Russ
__________________
Replacement Key Service http://https://the75andztclub.co.uk/...d.php?t=244732 Full T4 Testbook diagnostics available. Diesel ECU repair and replacement. Options enabled or disabled as required. Diesel X-Power 135 and "160", Rover 1.8T 150 to 160 MG 160 V6 to 177 upgrades available P.M. for details. Last edited by BigRuss; 3rd May 2009 at 19:09.. |
3rd May 2009, 19:09 | #8 |
Gets stuck in
ZT-T CDT 130+ (04) & 75 Tourer CDT Auto (52) & a 1998 MGF (with HGF!) Join Date: Mar 2007
Location: Halifax
Posts: 903
Thanks: 0
Thanked 1 Time in 1 Post
|
Greeners just got me thinking...
When I put the red tourer back together after swapping engines it started on the first turn and seemed to tick over fine. When I tried to move it off it went for about 10 feet and then started to splutter and die as if it had lost fuel. After that it started again but only ran for a few seconds before cutting out. It did this for a while as I searched through the engine to see if I had missed a hose. Eventually I unplugged the maf and it ran fine. I think the donor engine had been run with a synergy and pburg maf and the owner had put the old maf back on after the crash (it had air intake mod so likely owner was in the know about such things) The moral of this story is a really knackered maf, or something else in the breathing system, can cause this sort of symptom.
__________________
Jim Replace in tank fuel pump with Peugeot alternative Dismantle and re-fit interior and seats Retrofit electric memory seats without the loom All followed at your own risk! Available to borrow: I have a home made (tried and tested) Cam Locking tool for M47 should anyone need it. |
3rd May 2009, 19:14 | #9 |
Posted a thing or two
ROVER 75 CONNOISSEUR T SE WITH MISSING SATNAV ROVER P6 2000 SC Join Date: Jan 2007
Location: Doncaster
Posts: 1,484
Thanks: 429
Thanked 77 Times in 44 Posts
|
going to change the maf, see what doesnt happen, back in 5 mins
__________________
Back in Rover land, with 1.8T and Freelander HSE 2.0 td4 |
3rd May 2009, 19:18 | #10 |
Gets stuck in
ZT-T CDT 130+ (04) & 75 Tourer CDT Auto (52) & a 1998 MGF (with HGF!) Join Date: Mar 2007
Location: Halifax
Posts: 903
Thanks: 0
Thanked 1 Time in 1 Post
|
Just crossed posts Russ,
I can't see a new pump making any difference. In the end if your's is known to be working but didn't solve the problem I can't see the benefit of trying a brand new one. Does your pump and the original pump fire up when they are supposed to? EDIT - Tim, just unplug the maf and try it.
__________________
Jim Replace in tank fuel pump with Peugeot alternative Dismantle and re-fit interior and seats Retrofit electric memory seats without the loom All followed at your own risk! Available to borrow: I have a home made (tried and tested) Cam Locking tool for M47 should anyone need it. |
|
|