|
||
|
15th December 2017, 20:02 | #1 |
Loves to post
Rover 75 Tourer Join Date: Dec 2007
Location: Ammanford
Posts: 485
Thanks: 248
Thanked 29 Times in 24 Posts
|
Rover 75 & MG ZT Rear Number Plate Light Lamp Plinth Circuit Board
HI TO ALL
THE REAR NUMBER PLATE UNIT ON MY TOURER IS HELD ON WITH TORX BIT SCREWS WITH A HOLE IN THE MIDDLE CAN ANYONE TELL ME WHICH TORX BIT IS NEEDED DAVID |
15th December 2017, 20:21 | #2 |
SERVICING AND DEALER DIAGNOSTICS
MG ZT CDTI 135 + & MGZT CDTI AUTO 160 & ROVER 75 TOURER CDTI 160 TROPHY YELLOW Join Date: Aug 2013
Location: Hernebay
Posts: 4,331
Thanks: 818
Thanked 2,414 Times in 1,141 Posts
|
https://www.homebase.co.uk/kincrome-...-piece_p388456
I can’t remember off the top of my head but this set will have the correct security torx bit to fit and only for £10.45 I’ve used these loads and they are good value, I also have a decent blue-point set but they are much more expensive and not viable for a odd job. Anyway here’s the link at the top Mick
__________________
[SIGPIC][/SIGPIC] T4 Owner Jobs done : new UBP, Spy hole mod, Rear hub(wheel bearing),plenum cleaned and emptied, Inline thermostat fitted,Full service, In car Digital tv/DVD Bluetooth Satnav etc, Replaced UBP, Restored headlights,Fixed airbag connection.replaced HP pump,replaced rear light seals,changed intercooler O rings. Jobs to do: ,replace drivers lock,.[/SIZE] |
|
|