|
||
|
15th June 2021, 19:41 | #1 |
Regular poster
MG ZT KV6 (160) Join Date: Feb 2018
Location: Solihull
Posts: 36
Thanks: 0
Thanked 6 Times in 6 Posts
|
Drivers window- one touch
Drivers window one touch down working. Activated one touch up in toaf but then the window doesn't go up (have to keep pressing the switch on and off as window moves up a few mm at a time and when switch Is held moves a few mm then stops). Turn off one touch up in toaf and you can hold the switch and window goes all the way up manually but just not one touch.
Is there a reset procedure or is something faulty? |
16th June 2021, 11:16 | #2 | |
Gets stuck in
75 Tourer CDT MK2 manual in Glorious Grey Join Date: Jan 2018
Location: Slovakia
Posts: 987
Thanks: 926
Thanked 346 Times in 252 Posts
|
Quote:
__________________
Southern Slovakia Anything can happen in Formula 1 and usually does - Murray Walker 1999 Triumph Trophy 900, Saddlesore 1600, Iron Butt Riders Association #63720 2005 Rover 75 CDT Tourer MK2 |
|
16th June 2021, 12:36 | #3 | |
Gets stuck in
Rover 75 Saloon Join Date: Apr 2008
Location: Atherstone
Posts: 641
Thanks: 2
Thanked 52 Times in 36 Posts
|
Quote:
If recently added I would suspect " One shot up" and "One shot up anti trap" is not activated in the ZCS coding string.
__________________
Time is precious. Waste it Wisely ! |
|
16th June 2021, 12:45 | #4 |
This is my second home
MG ZT CDTi Join Date: Jan 2014
Location: carrick
Posts: 7,859
Thanks: 3,494
Thanked 2,657 Times in 1,973 Posts
|
Go back to toaf and check pinch is off. I seem to recall a similar issue, I'm trying to activate one shot on the passenger side. It made all the windows go into pinch mode as the bcu (I assume) was looking for the non existent sensor.
It has been a while, but i think if you uncheck all the modes, it will set it back to default. Sent from my SM-A600FN using Tapatalk
__________________
It is not gloss primer .............. it is duct tape silver! |
16th June 2021, 13:08 | #5 |
Regular poster
MG ZT KV6 (160) Join Date: Feb 2018
Location: Solihull
Posts: 36
Thanks: 0
Thanked 6 Times in 6 Posts
|
I seem to recall it happened around the time I turned off deadlocking in toaf. Have read it can cause some issues with other settings. So make sure close by pinch is deactivated? Anything else to check or uncheck on there that would affect one touch up?
|
16th June 2021, 18:18 | #6 | |
This is my second home
MG ZT CDTi Join Date: Jan 2014
Location: carrick
Posts: 7,859
Thanks: 3,494
Thanked 2,657 Times in 1,973 Posts
|
Quote:
My first use of TOAF caused an issue with the remote release, without me even opening that module! I had to go into it and uncheck the tailgate release (which had checked itself) and leave the boot/trunk release ticked. My car is a saloon, and the both tailgate and boot release were simultaneously checked. There are known to be bugs around TOAF, I suspect that that it has something to do with it being derived on BMW software (whose cars would have antitrap on all windows compared to ours on the drivers door). It is good enough though, but back everything up, be cautious, and if you are unsure, avoid using it.
__________________
It is not gloss primer .............. it is duct tape silver! |
|
16th June 2021, 19:29 | #7 |
This is my second home
R75 Saloon. Join Date: Feb 2009
Location: France/or Devon.
Posts: 14,003
Thanks: 3,851
Thanked 2,167 Times in 1,816 Posts
|
A very remote chance but you never know.---Disconnect the battery negative terminal for half an hour. Miracles can sometimes happen.---
|
16th June 2021, 20:15 | #8 |
This is my second home
MG ZT CDTi Join Date: Jan 2014
Location: carrick
Posts: 7,859
Thanks: 3,494
Thanked 2,657 Times in 1,973 Posts
|
plus one for this too (the mention of TOAF always sends me in that direction though from experience lol)
__________________
It is not gloss primer .............. it is duct tape silver! |
17th June 2021, 07:26 | #9 |
Avid contributor
2003 Rover 75 Tourer Club 2.5 auto, 2000 Rover 75 Club 2.5 manual, 2002 Connoisseur SE 2.5 Auto Join Date: Feb 2011
Location: Segovia, Spain
Posts: 170
Thanks: 127
Thanked 28 Times in 21 Posts
|
Same happens to me...
Hi Tom:
I have the same problem right now. I'm going to check this weekend to see if I can get it working properly again. If not I will make a backup of my other Rover that is working properly and restore it to see what happens. On the other hand, the miracle of the disconnected battery did not work for me. Kind regards Joel Antonio
__________________
My three amigos...!!! |
17th June 2021, 09:00 | #10 |
Regular poster
MG ZT KV6 (160) Join Date: Feb 2018
Location: Solihull
Posts: 36
Thanks: 0
Thanked 6 Times in 6 Posts
|
These cars keep you busy! So in toaf, close by pinch was active. After turning off, the window now goes up all the way when holding the switch but still no one touch up, even though activated in toaf. Have left battery off overnight and will reconnect and test later. Unfortunately, I did not take a backup so I cannot restore
|
|
|