|
||
|
6th June 2022, 15:55 | #1 |
Loves to post
Rover 75 Tourer, 2 X75 Saloon , MGTF Sunstorm Join Date: Jan 2013
Location: Guildford
Posts: 380
Thanks: 497
Thanked 172 Times in 93 Posts
|
Plenum rod bust!
As part of my continuing project to recommission one of my 75s after a long SORN I did some Plenum rodding. This went fine until I cleared out what I think is called one of the 'Lower Plenum drains' ie the one just in front of the driver over the wing. There was quite a large clog which my trusty plenum rod eventually cleared but in so doing it then shot down a couple of foot and stopped with a sort of thud. Unfortunately , upon retracting it I found it had snapped , leaving about 9 inches right down below. Somehow I need to get it out but how ?! Do I recall that this drain flows water into the wheel arch if so , I could remove the wheel arch liner to reach it ? Any observations / ideas welcome.
|
|
|