|
|
|
|
|
|
||
|
|
||
18th September 2016, 17:12
|
#1 |
|
Gets stuck in
None at moment Join Date: May 2013
Location: Loughborough
Posts: 899
Thanks: 230
Thanked 125 Times in 113 Posts
|
V6 Manual engine to gearbox bolts
Haynes tells me there are 7 - one at the front is a nut and bolt, the remaining 6 are bolts. I have located some but not all.
Like a fool, when I took this apart I didn't label everything as I thought I would be doing the job quickly. I done a lot of internet searches but can't seem to find the right diagram on Rimmer Bros (which is usually my goto for this kind of stuff) - anyone got a picture or tow?/links/whatever? I have a tray of bolts - but I don't seem to have all the right ones  |
|
|
|
18th September 2016, 17:43
|
#2 |
|
I really should get out more.......
PRE LAUNCH 75/ZT 190/XJ 550 Join Date: Jan 2007
Location: carcroft doncaster
Posts: 2,866
Thanks: 101
Thanked 680 Times in 342 Posts
|
if you took them all out you have them all to put back
easy andy |
|
|
|
|
18th September 2016, 18:57
|
#3 | |
|
Gets stuck in
None at moment Join Date: May 2013
Location: Loughborough
Posts: 899
Thanks: 230
Thanked 125 Times in 113 Posts
|
Quote:
This is true and whilst pondering, I had a clean up in the workshop - only to find the one I was missing - there's the one which has a nut too - which I found, nut attached, under some junk - what a dummy. However, there are two different lengths, both will fit and I'm not sure which are the bellhousing ones (I think the others are engine mounts) I know I should've taken more care in the first place. |
|
|
|
|
 |
|
|
Linear Mode
