|
||
|
12th December 2019, 00:23 | #1 |
Regular poster
Connoisseur SE CDT Saloon Join Date: May 2013
Location: coventry
Posts: 74
Thanks: 27
Thanked 0 Times in 0 Posts
|
FBH diagnostics
Hi all was wondering if someone could give me some help .I've been having some issues with my fbh . So I decided to investigate a little further and made a diagnostic loom similar to this one with the addition of a wire to pin 3.https://rover.ebay.com/rover/0/0/0?m...2F192411838077 along with a cable like this which I use for Toaf https://rover.ebay.com/rover/0/0/0?m...2F392399423116 however no matter what I seem to do I can't get the wabasto software to communicate with the fbh weather it be using the loom I've made directly attached to it or though the car using the obd port. Do you have any idea where I'm going wrong I've seen talk of using a 1ohm resistor but am unsure if this is my problem and if it is how to apply it .
Many thanks Matt |
12th December 2019, 08:00 | #2 |
This is my second home
Rover 75 Saloon & Tourer Join Date: Sep 2012
Location: Lincoln
Posts: 14,911
Thanks: 1,630
Thanked 3,032 Times in 2,181 Posts
|
neither of your links seem to go to the appropriate item.
I would say the best thing is to fit the fbh to the car, plug it in and try to start it. Depending on what happens a more accurate diagnoses can me made. Can you measure the resistance of the glow plug? It needs to be 0.5 ohm or less Can you test to see if the water pump works? I'm not sure it may be polarity conscious. Check in the How to section, there may be guidance about possible faults if the FBH starts up and then dies. The pcb's are a weak point and it is common'ish for them to fail macafee2 |
12th December 2019, 12:59 | #3 |
This is my second home
Rover 75 CDTi Connoisseur SE & MG ZT Saloon 190 Join Date: Jun 2007
Location: Coven
Posts: 12,522
Thanks: 526
Thanked 1,877 Times in 885 Posts
|
Hi Matt
If you want to communicate with thermis test off the car you do need a 1ohm resistor on the k bus wire, when the switch opens it pulls the voltage up to 12v and when it is closed it pulls it down to 0v. It needs to be a resistor so the switch can overcome the voltage otherwise when closed and connected to 12v it would blow the fuse
__________________
www.midlandsnanomeets.co.uk Robs Car Gallery Coven near Wolverhampton WV9 2000 Cowley Built Rover 75 2.0 V6 Club SE/ Atlantic Blue/ Sandstone/Walnut (daily driver) 2003 Land Rover Freelander 1 TD4 HSE Helsinki Blue/Black Leather (swmbo daily driver) |
Thread Tools | |
Display Modes | |
|
|