|
||
|
16th June 2012, 17:29 | #11 |
Passed Away
2002 Pale Blue. Rover 75 CDTi Connoisseur auto. 170K miles Join Date: Dec 2008
Location: Near the M67.
Posts: 14,509
Thanks: 199
Thanked 585 Times in 397 Posts
|
What Arry said innit....
... |
17th June 2012, 05:53 | #12 |
Newbie
rover75 CDT Tourer Join Date: Jun 2012
Location: Bury
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
|
thanks Harry, how do l check these fault ,what would happen if immoblieser kick in, also it looks like the e.c.u.as been looked at, clips missing. bill.
|
2nd January 2021, 20:21 | #13 |
Regular poster
Rover 75 Facelift 54 plate saloon Join Date: Feb 2016
Location: Pulborough
Posts: 70
Thanks: 15
Thanked 4 Times in 4 Posts
|
I have simikar problem. 1v on injectors until running after Easystart up. Then 5v. Starts and runs when hot. No start when cold. New crank, cam, map and fuel filter. New glo plugs, swapped 1 injector for old known good one, same, no cold start! Has got gradually worse until no stat up unless easystarted. No flicker on speedo while cranking. HELP!
|
4th January 2021, 08:29 | #14 | |
MG ZT Join Date: Jan 2011
Location: Newcastle Upon Tyne
Posts: 20,151
Thanks: 3,565
Thanked 10,837 Times in 5,718 Posts
|
Quote:
I can only assume a dry joint on the PCB which made contact once there was warmth in the board. I would try this out.. remove the ECM and place it on a radiator for ten minutes, then plug it back in and see if the car starts normally from cold. Brian |
|
|
|