|
||
|
20th July 2021, 22:24 | #1 |
Gets stuck in
MG ZT 260, Rover 75 Connie SE auto Join Date: Feb 2013
Location: Redruth
Posts: 984
Thanks: 1,324
Thanked 399 Times in 271 Posts
|
Wobbly gear lever on 260
I've just noticed that gearchanges on the 260 are deteriorating. This happened before and the local Vospers main dealer diagnosed a failed gear linkage. Their repair only lasted a few months and it failed again. They attacked the issue a second time and said the heavy duty components they fitted should never fail again. That was about five years ago. I read somewhere that to fix the linkage properly it needed the engine/gearbox to come out and that if this wasn't done, there was a chance of damaging the drive shaft. Vospers told me they did it both times without taking out the engine.
I know that if I keep driving her, the linkage will get so wibbly wobbly I'll be going into fourth when I want second. Any advice from those who've been there before would be most welcome. |
21st July 2021, 07:52 | #2 |
Posted a thing or two
ZT260SE TF160 ZT135+ Join Date: Mar 2008
Location: Bristol / Cornwall
Posts: 1,029
Thanks: 145
Thanked 72 Times in 64 Posts
|
For job like that, stick to those that really know what they are doing.
Nick at Austin Garage up in Burton Upon Trent is the only person who touches my 260 now (I would use Dreadnought, but Scotland is further for me!) trust me, its worth the long drive!
__________________
colintf Colin Murrell MGF Register Regional Rep for Devon & Cornwall and Cotswold Regions MGCC Z Register Rep for V8 ZT / ZTT's http://www.two-sixties.com/main.htmhttp://www.mgfregister.org/ |
21st July 2021, 18:57 | #3 |
Premium Trader
Rover 75 Join Date: Nov 2010
Location: Devon
Posts: 33,774
Thanks: 8,837
Thanked 14,831 Times in 8,030 Posts
|
You will only damage the input shaft if the gearbox is removed with the engine in situ, when this happened to me a new clutch sorted the issue.
__________________
Lest we forget..
|
19th August 2021, 13:54 | #4 |
Gets stuck in
MG ZT 260, Rover 75 Connie SE auto Join Date: Feb 2013
Location: Redruth
Posts: 984
Thanks: 1,324
Thanked 399 Times in 271 Posts
|
I feel a trip needs to be planned now things have opened up a little. I'll give Nick a call with my laundry list lol.
|
20th August 2021, 04:23 | #5 |
This is my second home
Rover 75 Tourer/ MG ZT-T 400 Join Date: May 2012
Location: Lhanbryde
Posts: 3,278
Thanks: 2,627
Thanked 1,523 Times in 869 Posts
|
I believe it’s a roll pin that breaks and causes a problem, not saying this is what’s happening to yours but it does happen. As mentioned do not try and remove the gearbox on its own. One method I saw a friend use was from inside the car after removing the centre console was to drill the spot welds on the plate above the gearbox and this gave enough room to remove the lid and fix the linkage
|
|
|