handbrake adjuster nut stuck - Page 2

Boltonboy · 23rd January 2021, 13:47

i was thinking i will proberly try and Dremel through the nut and reuse thread if possible any ideas of the nut size for replacement

Arctic · 23rd January 2021, 14:53

Quote:

Originally Posted by Boltonboy

i was thinking i will proberly try and Dremel through the nut and reuse thread if possible any ideas of the nut size for replacement

Hi Mat.
I think its 6mm or 8mm thread nut size is 13mm

Boltonboy · 23rd January 2021, 19:11

thankyou mate found it on rimmerbros

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

23rd January 2021, 13:47	#11
Boltonboy Avid contributor Rover 75 classic se cdti\ mg zt 120 /rover 75 club 1.8 Join Date: Aug 2020 Location: Bolton Posts: 166 Thanks: 85 Thanked 13 Times in 10 Posts	i was thinking i will proberly try and Dremel through the nut and reuse thread if possible any ideas of the nut size for replacement

23rd January 2021, 19:11	#13
Boltonboy Avid contributor Rover 75 classic se cdti\ mg zt 120 /rover 75 club 1.8 Join Date: Aug 2020 Location: Bolton Posts: 166 Thanks: 85 Thanked 13 Times in 10 Posts	thankyou mate found it on rimmerbros